Part Cooling:
When printing for functional parts it’s best to print for strength it’s best to go hotter and low to no part cooling fans.
To maximise DREMC PC/ABS or ASA/ABS or ASA CF / PETG CF strength; fan is turned off and/or print at 265°c+
Recommended extrusion temp: 260-280°c (PC/ABS)
Recommended extrusion temp: 260-280°c (ASA/ABS)
Recommended extrusion temp: 275-300°c (ASA CF)
Recommended extrusion temp: 235-260°c (PETG CF)
Maximum recommended extrusion temp @ 12mm/s³: ~300°c
For all materials print in well ventilated room, best for enclosed printer for air filter ducted outside or run Nevermore to reduce the VOC.
Layer Height
Blog Post: https://www.cnckitchen.com/blog/the-influence-of-layer-height-on-the-strength-of-fdm-3d-prints
Video:
Extrusion Width
Blog: https://www.cnckitchen.com/blog/the-effect-of-extrusion-width-on-strength-and-quality-of-3d-prints
Infill Pattern
Further Print Tuning:
https://ellis3dp.com/Print-Tuning-Guide/
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article