This handy FAQ to read before you're build.

If you have any questions, please send a request or leave your issue/problems on Voron Discord. (https://discord.gg/voron)

0.1 Manual: https://github.com/VoronDesign/Voron-0/blob/Voron0.1/Manuals/Assembly_Manual_0.1.pdf

LDO Motors Kit Require Printed Parts: https://docs.ldomotors.com/voron/voron01/printed_part_guide_rev_a

Wiring Guide: https://docs.ldomotors.com/voron/voron01/wiring_guide_rev_a

DOUBLE AND TRIPE CHECK YOU PRE-LOADED THE CORRECT AMOUNT OF T NUTS

Q: LDO Hotend BMO Dragonfly PTFE Length for stock mini afterburner. 

A: Stick PTFE down the hotend, and measure ~7mm from the top. Please ensure your printed part is for BMO Dragonfly.

Q: Y Endstop not triggering after you already mounted your gantry and belts.

A1: If you see it barely actaiving the limit switch you can loosen the limit switch set self taping screw, this will allow you move/shift the limit switch over. In most case will fixed the actiavation issue if not please perform A2 to increase actuation distance.

A2: You can slighly bend the omron micro limit switch lever to increase actuation distance. Please only perform this if you only a couple mm away from actuation, if it more than couple mm you may need to double check your frame

Image & A2 Credit: timmit99#1319

Installing T-Nut after assembly.