General Troubleshooting
Have you just purchased a new nozzle or hotend or replaced a new bed? You may need to require reconfigure PID to ensure the nozzle/bed temperature is n...
Sat, 23 Mar, 2024 at 4:41 PM
Before you install your thermeristor, you should double check that you both purchased and received the working before installing. Apply the multimeter probe...
Sat, 3 Feb, 2024 at 11:55 PM
Before you install your heater cartridge, you should double check that you both purchased and received the correct voltage cartridge. Cartridges are laser e...
Tue, 13 Jun, 2023 at 9:56 AM
Teaching Tech (Youtube: Link) has a great resources on his github/webpage. If you have any suggestion, please submit to his github issues : Submit Issue ...
Thu, 21 Sep, 2023 at 9:43 AM
Teaching Tech (Youtube: Link) has a great resources on his github/webpage. If you have any suggestion, please submit to his github issues : Submit Issue ...
Sun, 26 Dec, 2021 at 12:29 PM
Steps for Resolving a Hot-End Clog, follow each sequentially until the issue is resolved: Gradually heat the hot-end to a temperature approximat...
Wed, 7 Feb, 2024 at 11:18 PM
You should always perform a hot tighten of nozzle when changing or installing a new hotend. It always best to remove/change nozzle when hotend is hot....
Wed, 29 Mar, 2023 at 10:03 AM
Mainboard End Using the image as guide, swap the green wire with the red. Here is how to do it: push the red wire further into the connector pus...
Tue, 11 Oct, 2022 at 7:48 PM
Stepper Cable JST-PH6 to PC2510 Stepper Motor side PIN 1 – A PIN 2 PIN 3 – B PIN 4 – C PIN 5 PIN 6 – D ...
Fri, 19 May, 2023 at 2:43 PM
Our recommendation for print tuning, it written with Voron in mind but suitable for all printer running on Marlin/Klipper. Guide: https://ellis3dp.c...
Sat, 25 Feb, 2023 at 6:24 PM