Replacing or tightening the nozzle on your Micro Swiss hotend is a crucial maintenance task for optimal 3D printing results. This guide provides step-by-step instructions on how to change and tighten your Micro Swiss nozzle, ensuring a smooth and successful process.
Guide:
- Preheat the hotend to exactly 220C
- Un-load Remove the filament from the hotend
- Unscrew the old nozzle, while holding the heater block in position using an adjustable wrench
- Screw in the new MK8 nozzle and torque it to 30- inch pounds (3.4Nm) while holding the heater block in position using an adjustable wrench
- Verify that the thermal break is still seated flush on top of the heater block after installation
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article